The liquid quantitative filling machine is an automatic quantitative liquid dispensing machine designed with an electric, crank, and piston structure, suitable for quantitative filling of hospital preparation rooms, ampoules, eye drops, various oral liquids, shampoo, and various water agents; It can also be used for quantitative continuous liquid addition in various chemical analysis experiments, especially suitable for liquid packaging in large, medium, and small pesticide factories.
Technical parameters of liquid quantitative filling machine:
Liquid volume range: 0.2-10ml (filling volume adjustable)
Filling speed: 10-40 bottles/minute (filling speed adjustable)
Accuracy: ± 0.5%
Voltage: 220V
◆ Dimensions: 220 × 145 × 350mm
Weight: 6kg
Product features of liquid quantitative filling machine:
1. Simple structure, reliable, and few faults;
2. Adopting a conical piston, it has good sealing performance, accurate dispensing volume, and easy adjustment of liquid volume;
3. The liquid contact parts are made of stainless steel and are easy to install and unload, allowing for sterile dispensing;
4. The cylinder, push rod, and piston are made of stainless steel material, which is corrosion-resistant and wear-resistant;
5. The speed is continuously adjustable and easy to operate.
Usage of liquid quantitative filling machine:
1. Before the machine starts working, the ground wire must be properly grounded, and then the appropriate standard injector should be selected according to the different packaging quantities. The general packaging range is for 100ml models, using a 100ml glass enema machine (or a dedicated stainless steel filling system produced by our factory can also be used); The 500ml model uses the specialized stainless steel filling system produced by our factory.
2. Pull out the syringe core and insert the screw sleeve onto the syringe core.
3. Place the upper clamp seat on the outlet end of the syringe sleeve, and tighten the nuts on both sides appropriately (when using a 5ml syringe, tighten the sleeve together, being careful not to tighten too tightly, as the outer sleeve is fragile).
4. Assemble the assembled syringe core and outer sleeve into one unit, and the injection system is now fully assembled.
5. Fix the valve with the arrow facing upwards and the arrow mark facing outwards onto the fixing screw with a nut.
6. Assemble the complete injection system, align the upper and lower circular holes of the injection system components with the upper and lower fixing rods, fit them on the bearings, and make their outer end faces flat with the bearing surface. When assembling the lower end, do not let the screw sleeve and the crankshaft collide to prevent abnormal noise when the upper crankshaft rotates (when correctly installed, the distance between the screw sleeve and the crankshaft is about 1mm). After the injection system is correctly installed, tighten the upper and lower fastening screws. Connect the syringe and valve connection nozzle with a short rubber hose. The inlet pipeline is connected to the inlet, and the outlet pipeline is connected to the outlet. To prevent entanglement of the inlet and outlet pipes, clamp them into the side ear of the casing.
7. When manually turning the crank, it should be able to rotate freely. Otherwise, if there is an assembly error, check whether the injection system is fastened to the rotating bearing.
8. If using the specialized stainless steel filling system produced by our factory for the 100ml model, please refer to the 500ml model for installation methods.
Liquid quantitative filling machine filling volume debugging: