The 2CY stainless steel magnetic pump (temperature resistance ≤ 250 ℃) (referred to as the magnetic pump) is a new product that applies the working principle of the coupling to gear pumps. The main material is stainless steel. Customized according to demand and processed, it has the characteristics of full sealing, no leakage, and its performance reaches the level of similar domestic products.
Magnetic pumps replace dynamic seals with static seals, keeping the overcurrent components of the pump in a sealed state, solving the problems of running, emitting, and dripping that other pump mechanical seals cannot avoid. The 2CY stainless steel magnetic pump uses engineering plastics, steel jade ceramics, stainless steel, and other materials with good strength as manufacturing materials, so it has good corrosion resistance and can protect the transported medium from pollution.
1. Can be used as a transmission and booster pump in oil transportation systems;
2. In the industrial industry, it can be used as a lubricating oil pump;
3. A fuel pump that can be used for delivery, pressurization, and injection in the fuel system;
4. 2CY gear oil pump can be used as a hydraulic pump to provide hydraulic power in hydraulic transmission systems;
1. Installation
a、 Before installation, it is necessary to check whether the pump has been damaged during transportation, such as whether the motor has been affected by moisture, whether the dust covers at the pump inlet and outlet are damaged, and whether dirt has entered the pump chamber.
b、 Before installing the pipeline, the inner wall of the pipeline should be cleaned with clean water or steam. During installation, the weight of the pipeline should be avoided from being borne by the pump, so as not to affect the accuracy and service life of the pump.
c、 The oil pump should be as close as possible to the oil tank; The connection parts of the pipeline must not leak air or liquid, otherwise there may be a phenomenon of not being able to absorb liquid.
d、 To prevent particles, impurities, and other contaminants from entering the pump, a metal filter screen should be installed at the suction inlet.
e、 It is recommended to install vacuum and pressure gauges on the import and export pipelines to monitor the working status of the pump.
f、 When the oil pool is deep, the suction pipeline is long, or the medium viscosity is high, causing excessive vacuum, the 2CY gear oil pump can thicken the inlet pipe by one gear. When the oil suction pipeline is long, a bottom valve should also be installed.
a、 Are the fasteners of the pump secure.
b、 Whether the rotation of the active shaft is uniform and consistent in weight.
c、 Is the valve of the inlet and outlet pipeline open.
d、 Whether the rotation direction of the pump meets the requirements.
e、 Before initial use, an appropriate amount of medium should be injected into the pump.
3. Maintenance during work.
a、 The readings of the pressure gauge and vacuum gauge of the pump should comply with the technical specifications specified for the pump.
b、 When there is abnormal noise or high temperature rise during the operation of the pump, the pump should be stopped immediately for inspection.
c、 In general, it is not allowed to adjust the Anran valve arbitrarily. If adjustment is necessary, an instrument should be used for calibration. Make the cut-off pressure of the Anran valve 1.5-2 times the rated pressure of the pump.
4. Stop the pump.
a、 Cut off the power supply.
b、 Close the inlet and outlet pipeline valves.
