Welcome to Botou Zhuobo Machinery Factory
contact
Contact us contact
Contact Form
  •  看不清?点击更换
RETURN
POSITION:Home > News > Company dynamics >

How to use gear pump gear pump gear pump correctly?

Publication time:2024-10-04

NEWS DETAILS

The installation of gear pump can be carried out in accordance with the instructions, or the personnel of professional gear pump industry can be found.When installing kechang hydraulic gear pump, it is necessary to pay attention to the following points:

The drive shaft of gear pump can not bear any radial vertical force gear pump and other lateral drive modes

The strength of the bottom plate should be high and time should be controlled. If the bottom plate of gear oil pump is too soft, it will cause the asymmetry between motor and gear oil pump and damage the gear oil pump.

The inlet and outlet of gear pump can not be installed in reverse, otherwise it will cause no discharge of materials, and it is easy to break the gear pump.

It is necessary to determine the maximum rated pressure and speed, which cannot exceed the rated speed. The overpressure work will seriously affect the operating performance efficiency of gear oil pump.

The correct way to start the department's new hydraulic gear oil pump:

1. Check whether each part is normal without damage or parts, open before in symmetrical heating, heating speed 45 ℃ / hour,

2. Open the inlet valve of gear oil pump;

3. Open the gear oil pump and observe whether it starts normally.

4. The operating temperature of gear pump needs to be kept between -20 and 80 degrees, and the service life of gear pump will be affected if the temperature is too high or too low

Kechang hydraulic gear pump material is good: the high pressure part of gear pump material is hard aluminum alloy.High pressure plunger is made of stainless steel.And adopt double seal.Light weight, stable transmission.